Brakes hold a vital position in the anatomy of your car. It is one of the security features of your car so
you should always keep this under constant checking. Brakes should also be maintained and any call for repair
should always be addressed immediately. There are different kinds of a brake problem, as a driver and car
owner you should be equipped with some troubleshoot car repairs 101. This will ensure the longevity of your
car and may save your life too in the future. Sometimes brakes become weak or produce a grinding sound,
whatever brake problem you see must be repair urgently because you do not want to compromise your
Start the troubleshooting by finding a safe place where you can park your car and stay. Make sure that
you’re not getting in the way of other motorists and the place is safe for a stalled car. You may do the checking
with an off engine if your car does not have power brakes. The easiest way to determine if you are
experiencing a brake trouble is to step on the pedal and hold it down. While your foot is pressed down on the
pedal observe how the pedal reacts. I had to go through this process myself when my brakes started acting up while driving through Lubbock, Texas. I searched for tow truck lubbock and found the best tow truck service the city had to offer. Anyway, here are some brake problems that occur often and how you can troubleshoot them.
1. To start press down the pedal, make sure to keep a constant amount of pressure. Observe how the
brake pedal reacts. Here are the following indications that you have a brake problem:
Brakes are weak and spongy and go too low – a spongy or weak brake can be attributed to wearing off.
You can still use them but you might experience that your car takes longer to stop and weaker braking
power at sudden stops. Here’s how to repair it:
Have your brake fluid checked, usually spongy brakes have low level of brake fluid. Repair this by topping off
to the mark of the fluid placement.
o If air penetrated your brake system the fluid can be contaminated. You troubleshoot this by
removing the water that formed during condensation and replenishing it with a new fluid.
o Your brake pads might be worn off already, so it’s time to change them.
Brakes are too firm – if the brake pedal feels too stiff it might be experiencing the following:
o Vacuum Leak – to give you an overview, there is a brake booster that enables you to press you
brakes with ease. This booster has a vacuum system that activates the brake. If it happens that a
vacuum experiences some leaks it weakens its boosting performance. Look out for the leaks, if
you do not see one maybe your brake booster is not of good quality and you may want to replace
it. Bring it to a car shop to be checked by technicians.
o Blocked Brake Fluid – there are cases where brake fluid does not smoothly flow, it might be caused
by some blockage. Check your brake lines for any blockage and replace if needed.
Brakes sink to the floor – if your brake has little or no pressure and sinks to the floor and almost no
braking happens this might be caused by the following:
o Check the level of your brake fluid. Low fluid level sometimes causes the problem.
o Contaminated brake fluid. Even a small hole can serve as entry for air and once air penetrates the
system it affects the performance of the brake. Extract the air and replace the fluid.
o A defective master cylinder results to no brake pressure. You need to replace this defect.
2. If your brake seems to pull your car to one direction you may have a worn out brake pads. Worn out
or bad pads can cause trouble if continued using, so it is better to replace them to prevent further damage.
Also check your brake discs because they might also cause the problem. Replace it immediately if needed.
3. If your brake pedal vibrates, look for the factors that might be causing it like worn out brake pads,
defective brake discs, out of alignment, and worn suspension parts. Most of this problem can be troubleshoot
easily by checking and replacing as necessary.
4. If your brake is making a prominent sound it might mean that there is a loose part that needs to be
tightened. A good look will help you determine the problem.
If you have troubleshot the problem, test drive your car around a safe neighborhood or area. If the problem
still persists, take it to a car shop. Brakes are not something to be taken for granted because aside from your
seatbelt, brakes keep you safe while driving. Also one way to prevent a brake problem is regular checkup and